PurplePixie
n wireless customer care, and Verizon tied Alltel and T-Mobile for first place in a customer care performance study. Factors such as hold time and first-contact problem resolution were used to score each company. Sprint, on the other hand, received a two-out-o f-five for its customer care rating.Materials To build a biquad antenna, you will need a 123-by-123 mm square section of blank pri nted circuit board PCB, a short length of CNT or LMR-400 low-loss coaxial cable about 300 mm long, 50 mm of 12-inch copper pipe free html website templates and an N connector. The Reflector Cut a 123-by-123 mm square from the blank printed circuit board and clean the section thoroug hly with steel wool and polish. Next, cut a section of copper pipe that is 50 mm. Cut a 2-mm deep notch into one side of the pipe, PurplePixie stretching half the circumference. File both ends until they are completely smooth. Use a file or sandpaper for this. Polish the .
hat the notched end is on the copper side of the PCB. The pipe should protrude about 16 mm if you measure from the copper side of the PCB. Solder the two pieces together around the hole. The Element The element is comprised of a copper wire bent into two 30.5- by-30.5 mm connected squares, or diamonds as they appear. To build this, you need a 244-mm length of 1.2-mm copper wire. First, ma ke a pronounced 90-degree bend exactly in the center. Continue to make the same bends every 30.5 mm until you have a symmetrical s ice texture hape consisting of two connected squares that are exactly the same size. Putting It Together Solder the unconnected ends of the el ement to the copper pipe so that the opposite 90-degree angle sits in the notch and is centered in the middle of pipe. The element PurplePixie should not touch the reflector. It should sit almost exactly 15 mm away from it.Strip about 30 mm of the outer sheath from the co .
e sure the conductor is not touching the pipe. Crimp the other end of the copper pipe to the coaxial cable. Attach the N connector to the other end of the cable and the antenna is done.Default Network Settings For the most part, wireless routers, when powered on, work with default settings. Therefore, many users do not change the router's IP address or usernamepassword, or enable advanc ed security settings. Users should always personalize the default settings prior to connecting devices to the network. Data Interc 3d model free eption If encryption is disabled on the router, then data is susceptible to interception or man-in-the-middle attacks. The use of security encryption mitigates this danger and prevents access to the router and possible identity theft. Unauthorized Access Media PurplePixie access control MAC address filtering prevents unauthorized devices from gaining access to a home network. Unrestricted access a .
