PurplePixie
ouch both of the header pins simultaneously with the tip of the screwdriver carefully for about one second. If the computer turns on as if the power switch had been depressed, the computer power circuit is working correctly.1 Set the jumpers for the secondary hard drive to Primary Slave. The jumpers can be found in the back of the hard drive. To set the jumpers, pull the small black co nnector away from the pins using tweezers. Reset the pin according to the schematic in the hard drive's owner's manual. 2 Open the font styles computer's case by removing the side panel. Newer computer models have a release button or latch that is depressed or pulled to r elease the side panel. The panel is then lifted up and away from the chassis.On older computers, you may need to remove the mounti PurplePixie ng screws before opening the panel. Using the Phillips head screwdriver, remove the two screws and then lift the side panel up and .
ews that came with the new drive. 4 Plug the IDE cable from the motherboard into the back of the new hard drive. Being the slave d rive, the IDE connector with the grey end must be used. Once the IDE cable is connected, attach the power cable that runs from the power supply to the new hard drive. 5 Start up the computer to test the new drive. If the computer does not recognize this drive, turn off the power and make sure that everything is connected properly. If the drive is recognized, power down the computer and r house icon eattach the side panel.1 Right-click the wireless icon in the system tray of the Windows task bar. This icon looks like a computer with a small image of Earth over it. When the menu pops up, choose Connect to network from the options. This opens a windows di PurplePixie alog box with a list of available wireless networks. 2 Choose a network on which to connect. If your network has broadcast turned .
ssword is set by the network administrator. Ask the administrator for the password. Press the Enter key when you are finished. 4 Click the OK button when the summary dialog box is shown. This closes the network security connectivity window. 5 Open a web br owser to test the new connection. Enter a website in the navigation window. If the login was successful and you have access to the network, you should be able to connect to a remote website.1 Insert the CD that came with the printer into one of the computers t customer service resume hat will use the printer and that is currently on the network you want to connect the printer too. 2 Follow the instructions on th e auto-run screen to install the printer network utility. 3 When prompted by the installation screen, turn on the printer but do n PurplePixie ot connect it to any computers unless told to do so by the installation screen. 4 When prompted by the installation screen, give t .
