PurplePixie
le coming out of the converter cable into your IDE hard drive. 3 Connect the slender red SATA cable with the L shaped connector to the motherboard and to the converter cable. 4 Connect the male end of the power cable with the yellow, red and black wires to the IDE hard drive, and connect the female end to your power supply. 5 Power on your computer.The Wire Strainer Wi-Fi Antenna 1 P urchase a USB Wi-Fi adapter. Wireless n adapters are the latest and fastest, but wireless g adapters work well, and can be found o html templates n eBay for $15-$16 or at outlets such as Staples for as little as $30. 2 Cut an opening in the center of your wire mesh strainer. This serves as your parabola. The opening should hold the USB adapter firmly. 3 Insert the USB adapter into the center of the stra PurplePixie inerparabola. The USB connection end sticks out the back of the strainer. The increased surface area of this parabola will boost .
ection Wizard to configure your Wi-Fi reception. 7 Hang the Wi-Fi antenna. The parabolic surface and the Wi-Fi adapter should face the direction of your nearest AP access point. 8 Position the antenna carefully until maximum signal strength is obtained.Compo nent Communication Computers have a variety of components inside the case. Even when you're not doing anything, the computer is wo rking. The memory, sound cards, hard drives, video adapters, networking adapters and other hardware share resources, all controlle cg textures d by the computer. The IRQ When the component needs resources such as memory or access to data, it issues an interrupt request. Each component is assigned an IRQ interrupt request line: a number that tells the computer which component wants to do something PurplePixie . The vast majority of hardware resource conflicts arise when two components share the same IRQ. Find The Problem On Windows compu .
lay PnP in the late 1990s eliminated most hardware resource conflicts. Today, most HRCs occur when using legacy old components , or when two similar components such as two video cards or two hard drives are installed in a system not designed for such redu ndancy.Change Router Settings 1 Connect to the Internet using your wireless router and then click Start, Run, type command, and click OK. 2 Type ipconfig into the command prompt and press Enter. 3 Record the number listed as your default gateway. I 3d model t will likely be something similar to 192.168.1.1 or 192.168.0.1. 4 Open a Web browser and type the number you recorded in step 3 into the address bar and press Enter. A log-on prompt will appear. 5 Enter your network's user name and password and then click PurplePixie OK or press Enter. If you have never set up a user name or password, these may be set to factory defaults; consult your router .
