PurplePixie
iently deleted from the index and the bytes of the file itself can be allocated for another purpose.Software RAID. 1 Turn off your computer, unplug the power cord from the wall outlet and open the case. Check your motherboard manual and connect the hard drive to the RAID ports on your motherboard. 2 Close the case and plug back the power cord. Start your computer and to in your operating system. Check your motherboard manual to create a RAID array using the RAID software provided with your motherboard. 3 Go to the steel texture hard drive management tool of your operating system to create a partition on the RAID array created. Hardware RAID 4 Purchase a ha rdware RAID card. Be sure to purchase a RAID card that is compatible with your motherboard. 5 Turn off your computer, unplug the p PurplePixie ower cord from the wall outlet and open the case. Slide the RAID card in a compatible slot and secure it with a screw. 6 Connect t .
ear before your operating system starts loading. Check your RAID card manual or the screen and press the key to enter the menu. 8 Use your RAID manual to create a RAID Array of your choosing. Save your settings and exit the RAID menu. Go in your operating syst em hard drive configuration tool and create a partition on the RAID array.1 Click the Windows Start button. From the list of opt ions, select Printers and Faxes in the menu window. This opens up a new dialog box. Click the Add a printer icon to start the architecture models wizard that guides you through the process. 2 Click the Next button at the opening screen. After the screen appears, select the A network printer or a printer attached to another computer option. From this screen, click the Next button again. 3 Click the PurplePixie Browse for a printer button. This opens a new dialog window. Double-click the computer on which the network printer is attached .
. 5 Click the Finish button once the drivers are finished installing. You can verify the printer is installed by going into the control panel and double-clicking the Printers icon. Within this window, you will see the newly added printer.1 Wash and dry you r tin can. Remove any paper labels from the outside of the can. 2 Solder a piece of 14-gauge copper wire to the top of a female N- connector. 3 Measure your can from the base and mark a point exactly two inches above the bottom of the can. 4 Drill a hole in the leptin diet top of the can at the exact center. The hole should be large enough that you can insert the female N-connector snugly. 5 Apply gl ue to the female N-connector to secure it to the mounting hole in the can. 6 Connect the cantenna to your Wi-Fi router or adapter PurplePixie using a male N-connector. 7 Point the cantenna and adjust until you achieve the best decibel gain.1 Click Start and then Contro .
