PurplePixie
e new to setting up a modem on a computer, this whole process may be better left to an experienced technician to go through before you go any further if you are trying to do this from scratch. If you are ready to set up your wireless network key, however, go a head and move to the next section. Setting Up the Key The way to access any network and see its inner self is by accessing the IP Internet protocol,which means entering 192.168.0.1 in your address bar. When inside here, you will see many options. Don't alter icon archive any of the settings except for the wireless network key settings so as not to disrupt the Internet service in any way. Many of th ese IP setups will have the wireless settings in the Advanced tab. Clicking on this tab will take you to another page, where you w PurplePixie ill begin looking for the wireless selection. Inside here, you will see the options to do many things, including turning your wi .
ch is where you will build your wireless network key. A wireless network key is a binary set of 10 numbers and letters put togethe r to keep your computer safe and not allow a generic password to be put in. You will then put in a password that has to be 10 char acters and cannot have more than 2 numbers or letters next to each other of the same value. For example, you can have EE but not EEE in consecutive order. It would also be best to write this password down for future reference before saving. Once you have cre certificate templates ated your wireless network key, save it and allow the modemrouter to restart. Finalizing Your Work Once your connection has reset , try to get into the network. If all of the steps were followed, you will be asked to type and retype your wireless network key i PurplePixie n two boxes. Once you have completed the process, you should be able to access your Internet connection through the security wall .
proximately a trillion. A byte is composed of 8 bits. A bit is the smallest possible amount of data a computer can store on a hard disk. Source and Destination When imaging a hard drive, the drive being imaged from is generally called the source drive. The h ard drive being imaged to is commonly called the destination or target. Partitions A hard drive may be sectioned into multiple areas, called partitions. Each section is only a percentage of the size of the entire hard drive. At least one partition is neces free romance books sary for the storage of data on a hard drive. Partition Imaging Replicating a partition that is smaller than the entire hard disk does not require a destination hard disk the size of the source hard drive. Imaging a partition, thus, requires only a hard disk w PurplePixie ith a usable capacity that is at least the size of a source partition. Disk Imaging Imaging an entire hard disk involves using a d .
