PurplePixie
s to work best if you use routers and wireless adapters that are produced by the same company. 6 Put a wireless repeater between y our computer and your router. A wireless repeater is a device that takes in wireless signals and sends them back out, extending th e effective range of a network. Placing a wireless repeater at a point about halfway between your router and computer can signific antly boost signal strength.1 Attach both AirPort units to a power source and allow them to boot up. Connect to the wireless netwo lock icon rk provided by the first unit, which is the one attached to your cable or DSL modem. Launch the AirPort Utility located in the U tilities subfolder in the Applications folder and then select the base station in the left-hand column. Click on Manual Setup PurplePixie and then the Wireless tab and confirm the Wireless Mode option is set to Create a wireless network. 2 Make a note of the wireless .
ded by the second AirPort unit which has a default name that contains Apple. Highlight the unit in the column on the left in the AirPort Utility window and select the Base Station tab. Give this unit a name and password and then click on the Wireless tab. 4 Choose Join a wireless network from Wireless Mode on the second AirPort. Enable the Wireless Security to the same settings as no ted in Step 2 and enter the wireless password. Click the Update button and allow the unit to restart. 5 Confirm that both units ar letter of recommendation template e working seamlessly by relaunching AirPort Utility and verifying that both units are listed in the left-hand column. Also pull do wn the wireless network icon to make sure that there is only one wireless network that is being broadcast between these two units. PurplePixie 1 Unplug the damaged computer, pressing the power button once it has been unplugged to remove any electricity that might still be .
u wish to recover data from. It should be mounted in the front of the computer. 3 Disconnect the power cord and data cable from the hard drive, then unscrew the screws that are holding the drive in place. Carefully slide the hard drive out of the bay that it is mounted in. 4 Open the enclosure case that you will be mounting the hard drive in. Depending on the design of the enclosure, t his can be done either by removing screws or by pressing a release clasp. Set aside the panel that you remove from the enclosure. download books for free 5 Place the hard drive into the enclosure, lining up the power and data cable ports on the drive with the corresponding connectors inside the enclosure case. Gently but firmly press the drive back against the connectors until they are securely connected. 6 Rep PurplePixie lace the portion of the enclosure case that you removed when you opened it. Make sure you screw the screws back in or close the fa .
