PurplePixie
onnect to a Wireless Network. 6 Choose the wireless network to which you would like to connect from the list that appears. 7 Ente r the credentials username, password, or security key into the computer if required by your specific wireless network.1 Start th e computer and press a when the Grub boot menu appears. 2 Press the spacebar and type the word single at the end of the line, without quotes. Don't change any other settings in the line or the system may not boot properly. 3 Type init 3 and press Enter bill of sale template after the system starts. This command changes the current runlevel to multi-user, which is required to configure the graphical sy stem. 4 Type the following command to install the configuration wizard:su -c 'yum -y system-config-display'Make sure to include th PurplePixie e single quotes. 5 Type the following command to start the configuration wizard:system-config-display 6 Enter the model for your v .
screen is not visible, go back to the configuration screen and change the resolution to a lower setting. Continue this process unt il you see the test screen. 7 Save the settings and exit the wizard. 8 Type init 5 and press Enter to start the normal graphic al mode. The next time the system reboots, it will return to the graphical login screen.1 Power down the computer and remove all o f the cables connected to the CPU the tower of the computer. 2 Remove the Phillips screws around the side of the case. 3 Slide t cpm ebooks he case off to expose the interior of the CPU. Identify the current hard drive. It is, most likely, stored near the top front of t he computer and has two wires coming out of it: one thin and small, the other a few inches wide and skinny. 4 Remove the screws ho PurplePixie lding the current hard drive in place. There are four screws attached to a metal plate which holds the hard drive in the computer. .
Connect the two cables into the rear of the drive. The small cable connects the drive to the power source while the fat cable con nects the drive to the motherboard. 6 Close the computer case back up and reattach the cables and the screws on the exterior of th e CPU. 7 Power on the computer and insert the operating system installation disk into the CD drive. When asked what to boot from, select the CD drive. Follow the prompts to install the operating system onto the new hard drive. This process generally takes seve css examples ral hours to complete.1 Connect all of the hardware necessary to set up your D-Link wireless router. Connect the source of your In ternet, usually cable or phone line, into the back of your modem. Then,connect an Ethernet cable from your modem to the Ethernet s PurplePixie lot on the back of your D-Link router. 2 Connect another Ethernet cable from your router to your computer. Your D-Link router will .
