PurplePixie
pop up. 3 Restart your computer by pressing the alt-shift-delete combination of keys at the same time. This exits all of your ope n programs simultaneously. During a system crash, this command often won't work. Push down your computer's off button if this fail s. Wait for the system to reset and boot it back up. 4 Check what happens when your computer starts up again. These glitches might be because of a computer with low memory capacity. Sometimes bugs or viruses could be causing the problems. Your computer will al 3d models free ert you during the start-up if there are any hard drive failures or problems. The start-up process will be interrupted and your co mputer might just shut down on its own.1 Check to make sure that you have all the proper equipment to connect. For a DSL connectio PurplePixie n, you need the 2Wire DSL modem, power adapter, Ethernet cable and phone line. 2 Centrally locate the 2Wire modem in your house. T .
tach the 2Wire to a nearby computer by plugging the Ethernet cable into the network port on the computer. Plug the other end into the WAN or Internet port on the back of the router. 5 Turn on the 2Wire. 6 Watch the lights on the front of the router. These tell you your connection status. You should depending on the model see a green Internet and Ready light when the router has made a c onnection and is ready to start passing traffic. 7 Get the router login and router password. This is usually included in the infor DietBet mation and setup guides that come with the router, or they may be on a sticker attached to the back of the router. You will need t hese to configure the 2Wire. 8 Login to your router with a wireless-enabled computer. This is done by navigating to the address h PurplePixie ttp:gateway.2.wire.net with a web browser. On some models, this will be http:192.168.0.1 instead. Login with the router nam .
t is your wireless password. 10 Click Wireless Channel from the top of the screen. Underneath SSID Broadcast, click on the Enab le button. 11 Check the box labeled Enable located next to the Wireless Network Security option. In the Authentication menu, select WEP-Open. Select the Use Default Encryption Key option. 12 Click Save to save these changes to your router's configur ation file. Restart the router by clicking Restart the System underneath the System tab. 13 Test your router's configuration by 3d models free opening up a web browser on a wireless-enabled computer. When prompted, enter the network SSID from Step 9.With No SD drive 1 Plug the SDUSB cable into one of the USB ports on the computer. Plug the other end into the SD card reader if you have a device whic PurplePixie h uses an SD card, like a digital camera, you can use this as your reader. 2 Turn on the SD card reader. Your computer should rec .
