PurplePixie
limited to 11 Mbps, the maximum rate of 802.11b. Future As more and more devices connect to wireless networks, the demand for eve r higher speed wireless network grows. 802.11b and 802.11g are slowly showing themselves inadequate to meet this demand. 802.11n i s a newer standard edging out 802.11b and 802.11g with promises of higher speed limits.1 Turn off your wireless Internet router by unplugging the power cord from the back of the device. 2 Connect your wireless Internet router to your modem using an ethernet ca Abs Diet ble. Your wireless router will have a port labeled specifically for a connection to your modem. 3 Plug in the power supply for bot h your router and your modem and test to see if they are connected. You will see connectivity lights on your router if they have b PurplePixie een successfully connected. 4 If your laptop does not have a built-in wireless adapter, plug in the wireless Internet card into th .
your desktop showing you your wireless connectivity level.1 Install a SATA drive controller using an available PCI expansion slot on your computer's main circuit board. Firmly push the SATA controller card into the PCI slot until it is properly seated. 2 Reboo t the computer and enter the BIOS setup. 3 Enable the SATA PCI controller, if not already autoconfigured by the BIOS. 4 Boot the c omputer using the existing IDE hard disk. 5 Install the SATA drivers in Windows XP using the driver disk supplied with the SATA blender models controller. 6 Back up your original hard drive by creating a disk image to an external USB drive. Use a disk imaging software prod uct like Acronis True Image, Norton Ghost or Paragon Drive Backup. 7 Create a boot CD or floppy disk if your computer has a flopp PurplePixie y disk drive using the boot disk utility supplied by your drive image software. Ensure the boot disk includes USB drivers to allo .
ll the SATA drive into the drive bay used for the IDE drive. If required, install the same mounting screws removed from the previo us drive. Attach the power connector and SATA cable. Plug the other end of the SATA cable into the SATA controller. 11 Plug the US B external drive into an available USB port. 12 Boot your computer using the boot disk or CD created in Step 7. 13 Initiate restor ation of the drive image from the external USB drive using the software loaded by the boot disk. 14 Reboot the computer when the i star wars font mage restoration is complete. You should now find your computer exactly as it was except with a much faster hard drive.1 Open a co mmand prompt on your computer by clicking Start, clicking Run, typing cmd and then hitting the Enter key. 2 Type ping 123 PurplePixie .456.789.123 or ping computer_name where you substitute in the IP address or computer name of the computer you want to ping for .
