PurplePixie
dio devices will now be uninstalled from your hard drive. 5 Double-click on the audio device driver's EXE file that was downloaded in step one. This will begin reinstalling the drivers necessary for your soundcard to perform properly. There will be a set of pr ompts that you will need to follow in order for the driver to be successfully installed. When the installation is complete, your a udio device will be functional again.Pre-Replacement Precautions 1 Turn off the computer and unplug it. Never attempt to replace a stencil font ny computer hardware while the computer is running or connected to a power outlet. 2 Avoid setting the computer or its parts on ca rpeted surfaces. Set parts on a sheet of paper when they are not in the computer case to avoid exposure to static electricity. Sta PurplePixie tic can cause damage to computer components. Also, it is a good idea to wear an antistatic wristband available at many computer p .
Replacement 4 Unscrew and remove both side panels from the computer tower. The screws holding the side panels to the tower are ge nerally located at the rear of the computer on the far right and left sides, and there are usually two screws on each side. Once t he screws are gone, the panels can either be lifted off or slid toward the back of the computer to be removed. 5 Locate the CD wri ter that is to be replaced, and unplug all cables that are attached to it. There may be two or three cords. Take careful note wher social media logos e each cord plugs in for future reference. 6 Unscrew the CD writer from its position in the computer case. There are usually one o r two screws on each side of the CD writer, locking it into position in the computer. Remove and set these screws aside for later. PurplePixie 7 Carefully slide the CD writer out of the computer through the front of the case. Lightly push the back of the writer forward wi .
nstruction manual that should have come with the replacement CD writer.A master drive is the primary CD drive in the computer. U se this option if this will be the only CD drive in the unit or if there are more than one and this is to be the primary drive. A slave drive is a secondary CD drive, and should only be used if there is more than one CD drive installed and the replacement CD writer will not be the main CD drive. There is always only one master CD drive in a computer, but there can be any number of s power of attorney form laves. 9 Insert the rear end of the replacement CD writer into the new open cavity in the front of the computer face and slide it back until it stops. If it does not stop, adjust it so that the front of the CD writer is flush with the front of the computer ca PurplePixie se. Tighten the small screws that held the old CD writer into the sides of the replacement to hold it in place. 10 Reconnect the c .
